The test mode is an option to test the service without sending all the documents. Go to File > Auto Send Options > General Settings from the main EBMS menu to set this mode. Click on the Diagnostic Settings tab to view or change the following options:
Enable the Activate test mode to put the Auto Send module into test module. During an Auto Send module test, no documents will be e-mailed or faxed to the customer Instead all the documents will be sent from the Auto Send Module to the contact information provided. The Testing Type settings determines if the documents are sent to the set e-mail or fax number. You can set the maximum number of items during each test. A value of blank or zero will indicate no limit for the test. Note that you can only test one mode at a time. The mode is determined by the Testing Type.
The Logging Settings are optional ways of recording a log of the documents that were sent including the status of the send..
Enable the Create a general log for Auto Send processes option to create a log that will record each module function. This is useful for identifying a problem with the process. This option should be temporarily enabled while testing the process and is not required under normal circumstances.
Enable the Create a CSV log file each time Auto Statements are run to create a Comma-Separated Values (CSV) file when the Auto Statements process is run. This log will contain all the send information. A new file will be created for each run.
The log files are found in the Export Folder set within the general tab.